App: Installing the RemDroid application on your Android™ it is done in the same way as any other application on your device. Go to the Play Store & trade; application, search for RemDroid and press install; your Android™ device it will do the rest (if it has the available storage space).
WiFi: If the installation has a WIFI network, select the corresponding access point on the tablet or Android device. It is not necessary for the network to have an internet connection for the application to work.
MAP: Connect the MAP processor to a free port on the installation network. When the installation does not have a network infrastructure, proceed as follows:
Installation is simple:
- You will need a WiFi access point (This can be a WiFi router) and an Ethernet cable.
-
Connect the power cord of the WiFi access point.
-
Connect the Ethernet cable from any of the ports on the WiFi access point to the connector marked as "Ethernet" on the back of the MAP device.
-
With both devices turned on, wait a few seconds to allow both to start successfully.
-
Search your Android™ device in the section of available WiFi networks for the SSID of your WiFi access point (The default SSID usually comes just below the device on a sticker).
-
Once connected to WiFi, launch the RemDroid application on your Android™ device. and the application will search the MAP automatically.
-
In case RemDroid cannot find the MAP device, press the button “...” and select “Ethernet Ip Address” to manually select the IP of your MAP device .