The MAP connection to the network is made using a factory-supplied three-pole cable.

• Make sure the appliance's power switch is in the 0 (off) position.

• Insert the female connector of the 3-pole cable into the device's mains connector located on the rear panel.

• Insert the male connector of the 3-pole cable into the mains socket.

• Turn on the power switch on the appliance. At that moment all the front panel LEDs will light up in white and a check scan of all the LEDs will be performed, indicating that the unit has been turned on.

• After the sweep, the LEDs will go on to indicate the required function. The STATUS LED will illuminate green, indicating a correct operation of the unit, in the event that an error occurs at the start-up, said status LED STATUS will light red.